Sps calcium

You likely have an extremely low load then. Probably don’t need dosing except for the occasional testing and correction. But if your original question is, “is more calcium better”? No, around 420 is the best number.
 
Just don’t add it. It’s not going to hurt anything being that high. Just don’t add calcium until it lowers. Which means don’t use a balanced additive like kalkwasser or a calcium reactor. Avoid high calcium salts like Kent marine
 
So how do I lower it then. I have not added calcium in over few weeks.

What salt mix are you using? Some will mix a lot higher at 1.026 than others. And where’s your alk and mg levels? If your mg and alk are in line and things are growing fine you are likely okay.
 
Personally I wouldn't do anything to reduce. You are on the high end of cal. As load increases cal will decrease.
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 7 33.3%
  • Powerheads or wavemakers

    Votes: 2 9.5%
  • Sump or rear filtration chambers

    Votes: 2 9.5%
  • Skimmer or other filtration equipment

    Votes: 1 4.8%
  • Overflow or plumbing

    Votes: 6 28.6%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 9.5%
  • Other—tell us what I missed

    Votes: 1 4.8%
Back
Top
Home
Post thread…
Market
What's new