I am in the middle of rebuilding my tank 48x30x20! I want to make sure that i cut no corners this time and everything is %100 how i want it. I know there are some smart engineers on here, so i have some questions for you guys.
When building the stand, my dad and i didn't think about the hinges for the doors or support for my sump!!!***!
I am going to be cutting the front supports off and the rear-side supports for my hindges to fit. We are going to weld caps over them and supports on the bottom then paint the whole stand. For you engineers or just smart people with experience, will the one set of side and back supports be enough for the tank?
Front cuts.
Back side braces will be cut for my side doors.
All the input i can get Tonight would be great ( this is going to be done tomorrow)! Thanks for the help and i will keep you all updated with the progress. The stand skin is turning out nice! :third: for my poor planning!
When building the stand, my dad and i didn't think about the hinges for the doors or support for my sump!!!***!
I am going to be cutting the front supports off and the rear-side supports for my hindges to fit. We are going to weld caps over them and supports on the bottom then paint the whole stand. For you engineers or just smart people with experience, will the one set of side and back supports be enough for the tank?
Front cuts.
Back side braces will be cut for my side doors.
All the input i can get Tonight would be great ( this is going to be done tomorrow)! Thanks for the help and i will keep you all updated with the progress. The stand skin is turning out nice! :third: for my poor planning!
Last edited: