D3DPrintedThingz
Kind of a Valuable Member
- Joined
- Apr 29, 2022
- Messages
- 1,705
- Reaction score
- 1,410
- Location
- Stratosphere
- What state or country do you live in
- Australia
Does this tank need to have a flat surface under it?
Tank Support Question
- Thread starter D3DPrintedThingz
- Start date
- Tagged users None
RedReefer
2500 Club Member
I don't think so. It's made to sit on the plastic trim. You should only need support around the four sides.
Last edited:
fishywishy
Valuable Member
- Joined
- Jun 26, 2022
- Messages
- 2,116
- Reaction score
- 1,880
- Location
- Nunya business
- What state or country do you live in
- Texas
No. But I wouldn’t trust that table
OP
OP
D3DPrintedThingz
Kind of a Valuable Member
- Joined
- Apr 29, 2022
- Messages
- 1,705
- Reaction score
- 1,410
- Location
- Stratosphere
- What state or country do you live in
- Australia
OP
OP
D3DPrintedThingz
Kind of a Valuable Member
- Joined
- Apr 29, 2022
- Messages
- 1,705
- Reaction score
- 1,410
- Location
- Stratosphere
- What state or country do you live in
- Australia
This had a 125 gallon on it for years, and I added a back and side brace. What I was reading is the rimmed tanks don’t need the same support and this should be fine. Thank you!
IceNein
Well-Known Member
- Joined
- Sep 1, 2017
- Messages
- 907
- Reaction score
- 1,492
- What state or country do you live in
- California
My concern would be that while it's bottom does not need to be supported, the rim itself does. If the rim is hanging over that hole, then it is not supported along most of its length. Maybe it holds, but I wouldn't bet money on it.
Similar threads
