Tightening large schedule 80 bulkheads

Martingale

Active Member
View Badges
Joined
Sep 10, 2019
Messages
249
Reaction score
107
Location
St Leonard, Maryland
Rating - 100%
2   0   0
Any advice on how to tighten a 2” Sch80 bulkhead?

The round lock-nut, compared to the 6-sided lock-nut of ABS bulkhead, is a little harder to tighten. I was thinking I’d try a larger diameter vice grip or an oil filter wrench.
 
The oil filter wrench should do the job
 
An oil filter wrench with the teeth covered with electrical tape worked great and without carving into the fitting.
 
I'll happily second a good strap wrench. I work in a boiler room, 4" PVC fittings on the water softeners. Unless you want to snap plastic, strap wrench is the way to go.
 

TOP 10 Trending Threads

WHAT KIND OF REEFING DEAL ARE YOU HOPING TO PICK UP THIS BLACK FRIDAY?

  • A whole new aquarium or complete system

    Votes: 2 11.1%
  • Lighting, pumps, or other major equipment

    Votes: 2 11.1%
  • Controllers, testing, dosing, or automation gear

    Votes: 2 11.1%
  • Dry goods and restocks, like salt, media, or food

    Votes: 2 11.1%
  • Corals! Must...Have...CORALS!!!

    Votes: 5 27.8%
  • Fish or other livestock

    Votes: 0 0.0%
  • Rock, sand, or other aquascaping supplies

    Votes: 1 5.6%
  • I’m browsing, but don’t have a specific target

    Votes: 2 11.1%
  • I’m not shopping for reef deals this year

    Votes: 1 5.6%
  • Other (Post in the comments)

    Votes: 1 5.6%
Back
Top
Home
Post thread…
Market
What's new