Trident np calibration

[painter1982]

I’m trying to calibrate my trident np. I go into configure. I slide it to calibrate. I also mark “prime sample”? Or do I prime it with the sample then go back in and calibrate? The reason I ask is when I slid it to calibrate and marked prime sample it started doing its thing. But it has only sucked about 1/4” out of the calibration solution. That seems like it would still have my tank water in the machine and not actually using the calibration solution.

 

[bubbgee]

You should prime sample from the tank and then calibrate. Then after calibration, re-run the test so it reflects the values. But note that the values might still be wildly off until a week as it sorts itself out. Not sure why it does that but it got closer to my Hannah after a couple of days.