Trouble with new calcium salifert test kit

  • Thread starter Thread starter Llorgon
  • Start date Start date
  • Tagged users Tagged users None

Llorgon

Well-Known Member
View Badges
Joined
Dec 10, 2018
Messages
757
Reaction score
293
Location
Kelowna, BC
What state or country do you live in
Canada
Rating - 0%
0   0   0
Hey, I recently bought a new salifert calcium test kit as my old one was empty and I've been having a few issues with it.

The new instructions are add 2ml water, add a scoop of powder(don't mix) fill the syringe to the 1.00ml mark and put in to the lower end of the piston is at 0.4ml, swirl and the colour should go from blue to pink.

Only problem is it doesn't go pink. It just stays blue. If I keep adding it goes pink at the 0.2ml mark then blue again at 0.08ml mark.

So right now I am reading that as calcium being 460. Or am I way off since it didn't change colour when it was supposed to?
 
mark and put in to the lower end of the piston is at 0.4ml, swirl and the colour should go from blue to pink.
This step here is you already know where your CAL is at so you don't have to go 1 drop at a time starting from the 1ml mark. I usually go to the .5ml mark, then start 1 drop at a time.

So it sounds like the test is correct. You can double check again and see if its close to your last test.
 
ok. That makes sense. This is a newer tank so I am trying to find out what my calcium is at. I will try adding less at a time tonight.
 
ok. That makes sense. This is a newer tank so I am trying to find out what my calcium is at. I will try adding less at a time tonight.
I had an older salifert calcium test that did the same thing. The color never changed the way it was supposed to. However I have the same as you now and it works perfectly. I would be skeptical of the results if the test isn't performing as directions state.
 
I have the same issue. doesn't go pink till I get to the .25 mark, and then turns blue later. The reading I get is a lot closer to what I am expecting than 300, which is what the .4 mark is.
 
The new test from Salifert is a complete mess, I have overestimated the test solution from TM by 50 units. Salifert does not admit the mistake, he says that when the titrant evaporates, its concentration may increase and its indicators may change. If it does not change color then you need to shake the titrant
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 18 18.6%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.3%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.5%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.4%
  • I keep a backup of everything

    Votes: 25 25.8%
  • Other (Post in the comments)

    Votes: 7 7.2%
Back
Top
Home
Post thread…
Market
What's new