Tunze nano 3152 setup help Biocube32

[Themastaa]

I will be setting up a nano 3152 ato in my biocube 32. Not sure where I should put the water sensor, would it best in a rear chamber? Also how hard is it install? In my mind, water changes are going to be annoying to get it set back up correctly

 

[WIReefer]

I would place it in the last chamber. I also run a tunze nano on my qt tank it is super easy to adjust if needed.

 

[BoxKing]

Place the sensor in the chamber where your return pump is located, along with the tube feeding in your fresh water source. I’d place the in feed tubing as high above the water line as you can, to avoid the chances of syphoning.

 

[MammothWombat]

Place the sensor in the chamber where your return pump is located, along with the tube feeding in your fresh water source. I’d place the in feed tubing as high above the water line as you can, to avoid the chances of syphoning.

How deep should I submerge the float sensor?