Tunze nano 3152 setup help Biocube32

Themastaa

Active Member
View Badges
Joined
Mar 11, 2021
Messages
153
Reaction score
247
Location
Millville,NJ
Rating - 0%
0   0   0
I will be setting up a nano 3152 ato in my biocube 32. Not sure where I should put the water sensor, would it best in a rear chamber? Also how hard is it install? In my mind, water changes are going to be annoying to get it set back up correctly
 

WIReefer

608 MOD SQUAD
View Badges
Joined
May 10, 2017
Messages
5,159
Reaction score
27,801
Location
Wisconsin
Rating - 0%
0   0   0
I would place it in the last chamber. I also run a tunze nano on my qt tank it is super easy to adjust if needed.
 

BoxKing

Active Member
View Badges
Joined
Mar 31, 2021
Messages
186
Reaction score
162
Location
Philadelphia
Rating - 0%
0   0   0
Place the sensor in the chamber where your return pump is located, along with the tube feeding in your fresh water source. I’d place the in feed tubing as high above the water line as you can, to avoid the chances of syphoning.
 

MammothWombat

Community Member
View Badges
Joined
Oct 19, 2020
Messages
36
Reaction score
4
Location
United States
Rating - 0%
0   0   0
Place the sensor in the chamber where your return pump is located, along with the tube feeding in your fresh water source. I’d place the in feed tubing as high above the water line as you can, to avoid the chances of syphoning.
How deep should I submerge the float sensor?
 
Back
Top