Unable to change bulk reef supply rodi

What part? Prefilters canister? Are you using the wrench? Is it mounted to a wall?
The membrane housing? Big channel locks or pipe wrench should do it.
 
What are you using to try to unscrew it? Strap wrenches are handy for stuff like this.
 
What part? Prefilters canister? Are you using the wrench? Is it mounted to a wall?
The membrane housing? Big channel locks or pipe wrench should do it.
I am using the wrench provided and trying to get the sediment filter canister done. It is not mounted to a wall.
 
Mounting to the wall will help you get the leverage on there properly. Or try having someone else hold it while you wrench it. Sounds like it’s over tightened.
 
I put the wrench on it and tapped it with a hammer the first time. I didn't put them back that tight.
 
They can be really tough just keep at it and eventually it will loosen up .if it is mounted on the wall it is much easier
 
Unmounted creates a set of its own problems. NO leverage to work with.
 
yea I didn't have mine mounted and I had the hardest time unscrewing the carbon one. Had my wife sit on the bracket and I put their wrench as high as it could go. I eventually was able to loosen it. I am building a mixing station and will be mounting the RODI system to wall when I am done
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new