Brewman1987
Well-Known Member
I thought I would build a UAS hang on scrubber from some materials I had laying around.
For the build I used:
2- abs project boxes
4- 660nm Cree LEDs w/ driver from rapid led.
Needle point mat
Air tubing and pump.
2-part epoxy and neodymium magnets
I attached the LEDs to 2 pieces of aluminum heatsink with thermal adhesive, and soldered them together.
This is my first time running a scrubber, I may need to increase the airflow in the scrubber. Anyways here is a shot in action!
Dan
For the build I used:
2- abs project boxes
4- 660nm Cree LEDs w/ driver from rapid led.
Needle point mat
Air tubing and pump.
2-part epoxy and neodymium magnets
I attached the LEDs to 2 pieces of aluminum heatsink with thermal adhesive, and soldered them together.
This is my first time running a scrubber, I may need to increase the airflow in the scrubber. Anyways here is a shot in action!
Dan
