Purchased a used MP40, works great but you can tell it’s on a predetermined app configuration that I want to change.
it’s asking for a PIN? Does anyone know how to skip this?
it’s asking for a PIN? Does anyone know how to skip this?
Used MP40 Pin to reset?
- Thread starter WallyTime7
- Start date
- Tagged users None
OP
OP
It asks for the pin..
vtecintegra
Valuable Member
Try this even though someone said it didn't work for them. It's all I've been able to find so far.
support.ecotechmarine.com
VorTech Propeller Pump Controller Reset
Overview EcoSmart and QuietDrive VorTech Controllers have 2 different resets available to you. To perform a soft or hard Reset, see their descriptions and instructions below.Soft Reset: Clears the...
OP
OP
Thank you
I’ll try it out
I’ll try it out
vtecintegra
Valuable Member
Try this next. See if you can get to settings and click "remove passcode".
OP
OP
That one may not work since it’s not hooked to my tank just yet
ScottD
Active Member
Wally try this out if you haven’t gotten it yet. I ran into the same issue and following this work like a charm for me.
OP
OP
That was asked with no such luck, thanks
OP
OP
This worked - thank you
Similar threads
