Vectra M1 flashing red/purple

[mjt82]

Can anyone give me any insight into why my Vectra M1 is flashing red/purple? See video in link below. Thanks for any input!!

 

[watdachuck]

I believe red/purple is when it is awaiting assignment as a master or slave.

Were you in the midst of programming it?

If not I would just do a factory reset and start at the beginning.

 

[mjt82]

I believe red/purple is when it is awaiting assignment as a master or slave.

Were you in the midst of programming it?

If not I would just do a factory reset and start at the beginning.

Thanks for the reply! I’ll try the factory reset.