GillMeister
Valuable Member
- Joined
- Apr 1, 2020
- Messages
- 1,181
- Reaction score
- 1,565
I'm trying very hard to figure out any issues I''m having with my Apex instead of turning to Neptune or the forum members. Today, I had to unplug the base unit from the EB832 to do some cord management. After I hooked up again I wasn't able to connect to fusion because my Apex had no wifi connection.
I reset the unit multiple times and finally was able to get it to connect to wifi . As soon as Apex restarted all my WAV powerheads went to 100%. My tank looked like a snow-globe. My configurations were still set where i had them previously set and should have been running about 40%. No matter what I did, they wouldn't slow down.
The fix, as it turned out, was to delete all my WAV setpoints and then create a new profile for each powerhead. It was satisfying to get them working properly again but a little puzzling why I keep getting these strange glitches.
That's the end of the story. Very exciting.
I reset the unit multiple times and finally was able to get it to connect to wifi . As soon as Apex restarted all my WAV powerheads went to 100%. My tank looked like a snow-globe. My configurations were still set where i had them previously set and should have been running about 40%. No matter what I did, they wouldn't slow down.
The fix, as it turned out, was to delete all my WAV setpoints and then create a new profile for each powerhead. It was satisfying to get them working properly again but a little puzzling why I keep getting these strange glitches.
That's the end of the story. Very exciting.
