Why is my TDS higher out than in?

Sierra_Bravo

Valuable Member
View Badges
Joined
Jan 29, 2017
Messages
1,899
Reaction score
4,014
Location
San Antonio, TX
What state or country do you live in
Texas
Rating - 0%
0   0   0
Running the water through a 5-micron sediment filter to a 1-micron sediment filter, then through a 1-micron carbon block and into the RO membrane. The TDS meter's in/out sensors are orientated correctly. I have ~255 going into the first sediment filter but it comes out of the carbon block 2-3 points higher. The difference could be calibration between the two, but I would have expected the three filters to have more of an effect on reducing TDS prior to entering the RO membrane. Is this not usually the case?
 
Sediment filter removes sediment, Carbon removes organics, and the "membrane" removes TDS!

If it were me, I'd run one sediment and two carbon blocks....HERE.
 
Sediment filter removes sediment, Carbon removes organics, and the "membrane" removes TDS!

If it were me, I'd run one sediment and two carbon blocks....HERE.

I see, so sediment and organics don't affect total "dissolved" solids. That's obvious upon retrospect, I guess.

I decided to run two sediment filters because we have a lot of silt in the water currently with construction and water lines being replaced. I had been running only one but was having to replace it too frequently.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new