lickyricky
Red Sea Max E-170
I started my new aquarium 3 days ago. The pH is at about 7.5. Should it be at 8.0-8.3? will it raise naturally or do I need to buffer it? if so what is the best product to accomplish this?
pH??
- Thread starter lickyricky
- Start date
- Tagged users None
What is your salinity? It should be higher. I don't think it will raise on its own. Someone else with a better understanding will be able to answer.
ironworker
Active Member
We need more info. What are calcium magnesium and alkalinity at. They will all affect ph
OP
OP
lickyricky
Red Sea Max E-170
I just started the tank and did not buy any test kits for calcium magnesium and alkalinity yet b/c I was hoping to hold off till I get some more cash flow.
Pkunk35
Valuable Member
Did you use a salt mix? If you mixed it to proper salinity then most mixes will give you the proper pH. What's your salt mix and salinity at? Anything else in the tank at all?
ritter6788
Coral Fraud Private Eye
To me, buffers to raise ph are a waste of money and you are more likely to drive alkalinity too high which is worse than a slightly low ph. It may be as simple as increasing aeration.
An experiment you can try is take a sample of your water outside and aerate it with an air stone. Test ph of the sample and see if it increases. If so then you need to improve aeration in your tank or let more fresh air in the house.
An experiment you can try is take a sample of your water outside and aerate it with an air stone. Test ph of the sample and see if it increases. If so then you need to improve aeration in your tank or let more fresh air in the house.
Ace25
Active Member
When I moved from a house to an apartment I had low pH issues. Took me a few days to figure out the cause, which ended up being me closing the windows at night. When I closed up the apartment, pH would drop to 7.5-7.6, when I left the windows open it never dropped below 7.9 at night. First couple days I tried the airstone method and saw no difference, but that was because the air pump was pulling air from the room, which was high in CO2 when the windows were closed.
I agree with ritter6788, buffers usually end up doing much more harm than good when trying to use them for the purpose of raising pH.
I agree with ritter6788, buffers usually end up doing much more harm than good when trying to use them for the purpose of raising pH.
OP
OP
lickyricky
Red Sea Max E-170
That would be great if I didnt live in Florida where its always 95 degrees and 100% humid
OP
OP
lickyricky
Red Sea Max E-170
No, I used pre mixed salt water from my LFS
ritter6788
Coral Fraud Private Eye
I'm in Texas and its always 100 degrees and humid. :)
Young Frankenstein
I sniff ozone and relax.
3 days is nothing in this hobby, don't think you can even assume anything within 2 weeks of running a tank. Too many changes are happening. Any buffers are a temporary solution like ritter6788 says. Lighting, aeration, chemistry affect ph. Hit the books :) read some more here from Randy
Low pH: Causes and Cures by Randy Holmes-Farley - Reefkeeping.com
Low pH: Causes and Cures by Randy Holmes-Farley - Reefkeeping.com
OP
OP
lickyricky
Red Sea Max E-170
thanks for the read!! great info
OP
OP
lickyricky
Red Sea Max E-170
should I add an aerator to my biocube? would putting the pump just outside the window help bring air in from outside?
ritter6788
Coral Fraud Private Eye
How about a skimmer?
OP
OP
lickyricky
Red Sea Max E-170
I do not want to add a skimmer just yet. I just ready an article someone else suggested. Going to try that...I currently have a cup of water outside with an aerator in it...going to see if that raised the pH and then will repeat but inside to see if that has the same effect, if it does then I know my tank just needs more air. If it gets higher outside then I know I have too much CO2 in my house.
Similar threads
