0-10v

Hey and hello I recently set up my reef oct to the 0-10v interface. I also set up the stream group and min max. My question is how do I adjust the power output of the skimmer on the interface? I am running my skimmer at the eco mode level prior to adding the 0-10v and would like to adjust...

So I’ve got my overflow stabilized with the RO Varios controller on my Varios8 and Varios2, on Speed2. It took a bit of tuning especially with my fleece roller and ATO. I really don’t want to alter my pump speeds and go through the process all over again. I have the 0-10v cable, and I’d like...

In my pursuit to trigger feed and maintenance modes using a single push button, I have come across a few challenges. Sure I have a Profilux 4 controller which handles most of my pumps and such. And my plans include connecting some buttons to trigger the modes (likely something from Harry's...

Does anyone know if, when a 0-10v cable is connected to the Reef Octopus Octo Pulse pumps, do they switch to constant mode? Initially I expected this to be the case, I have an Apex program setup to ramp between 10% (lowest possible speed) and 30% (Highest I need, these things are powerful!)...

Hi all, i've just added an Abyzz Apex 0-10v port controller - Working great, however... Testing what happens if the connect between pump and Apex is lost... the pump shuts down! Is there a way to add a 'Fallback' to a 0-10v controlled device? Alternatively, possible to set a fallback on the...

EDIT: I decided to part this out. That thread is here LOCAL ONLY ($$$ to ship this thing would be absurd) WILL. NOT. PART. OUT. These lights were purchases from amazon in May, so they haven't been used long. No dead pixels or anything like that. Everything from the lights, mounts, t-slot...

I am looking for a way to limit the max output on the Apex 0-10v V1-V4 outputs or change the 10v default when output switch is in the ON position, Now I already have my program the runs my current DIY LEDs up to certain percentage but my concern is when I turn my output switch in Fusion from...