sciknen
Merrimack Valley Hardcore
Hey hows it going
Got an idea I'd like to throw your way. I know some of you are very very good at tank building and know the specs and safety factors and all that jazz.
I have a 125 with 1/2" glass the whole way around I want to cut up.
72" x22" cut it half will give me
4 pieces of 36"x22"
Not sure what to do to get these four. I have the bottom panel (not sure if its tempered???)
But also the back panel is drilled with 2 holes opposite corners? Any ideas would help
All i need is one front piece starphire of 36"x22". Which would also be 1/2"
Is that enough to do rimless? The 125g I have doesn't bow at all and has zero cross braces. All it has is the little crappy plastic rim around the top.
What do you guys think?
Polished and ground edges I guess are the way to go from what i read.
Thanks
Got an idea I'd like to throw your way. I know some of you are very very good at tank building and know the specs and safety factors and all that jazz.
I have a 125 with 1/2" glass the whole way around I want to cut up.
72" x22" cut it half will give me
4 pieces of 36"x22"
Not sure what to do to get these four. I have the bottom panel (not sure if its tempered???)
But also the back panel is drilled with 2 holes opposite corners? Any ideas would help
All i need is one front piece starphire of 36"x22". Which would also be 1/2"
Is that enough to do rimless? The 125g I have doesn't bow at all and has zero cross braces. All it has is the little crappy plastic rim around the top.
What do you guys think?
Polished and ground edges I guess are the way to go from what i read.
Thanks
Last edited:
