Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Where will your return pump be located? external?Is a 30g sump big enough for a 180g tank? I will only have a filter sock/poly filter and a skimmer in the sump. Refugium and ATO reservoir will be separate.
Internal pump. Planning on a Vario-S 8. That should give me plenty of flow to run a few reactors off a tee in the return line.Where will your return pump be located? external?
Just make sure that you have enough space in the sump for the water that will drain back Incase of a power outage or return pump maintenance or failure.
It is small for a sump. I have a Reef Octopus 150 skimmer. It fits easily. Not planning on much of a bio load. Mostly LPS corals. I'm hoping the skimmer is big enough.Pretty small in that it may be hard to get a properly sized skimmer in there. A 180 is a big tank, and it would be great to have space for maintenance-minimizing equipment.
All i had was a 30 gallon eshopps sump for my first sump it worked fine up until my check valve failed then it flooded my front room but it is easy to upgrade I just drilled it and added another 30 gallon. If you're on a budget I think you'll be fine just make sure your return lines aren't too low so if your check valve or anything like that ever fails it won't drain too much water into it
A Y check valve will stop that.@Rcpilot Dont forget, if your return lines are below the teeth line on your overflow, you will also have some drain down potential there. even with a weep hole.
Yep, figured that when I bumped the 7.5--8g up to 10g to account for the water in the pipes.@Rcpilot Dont forget, if your return lines are below the teeth line on your overflow, you will also have some drain down potential there. even with a weep hole.
Good idea check out craigs list or such. you might find a beat up 75 for cheap. Use the 30 for that future frag tank !