I was getting tired of lifting the screen on the tank to feed the fish everyday. Just about 20 min later I had this designed, and by that afternoon I was installing it.
Overall 3.5 inches, 5mm thick, 2.5 inch opening port for feeding.
Used PLA+ for construction since it does not sit in water.
Going to be making a second one for the other side of the tank.
Simple installation: Screw top and bottom together with the 3D printed screws, and then cut the screen out.
Overall 3.5 inches, 5mm thick, 2.5 inch opening port for feeding.
Used PLA+ for construction since it does not sit in water.
Going to be making a second one for the other side of the tank.
Simple installation: Screw top and bottom together with the 3D printed screws, and then cut the screen out.