Analyse my heavy and trace metals ICP

[Nixmo]

Hi Reefers

I have had an issue with copper so I had a metals ICP done. I'm now running cuprisorb, metasorb and polyfilter in a reactor so copper should be lower than the shown ICP results.

Is there anything else in there i need to be concerned about? Anything needs raising or lowering and any tips?

I've uploaded the results as a spreadsheet

TIA

 

[Randy Holmes-Farley Verified Community Expert]

The 20 ppb (0.02 ppm) copper is fairly high. May not be a problem as my tank was about 0.013 ppm when I tested it, but did you ever use copper or are you using tap water?

You might (or might not0 benefit from other trace elements added. Are you dosing any?

 

[Nixmo]

I'm dosing standard alk, mag, ca + quantum bio enhance.

Long story but I believe copper was the initial problem. All new corals are doing well and ploy-filter pads have pulled out so much in the past 2 weeks. BTW this sample was submitted approx 2 weeks ago, so copper definitely lower.

Just not sure if any other elements are out of range

 

[Randy Holmes-Farley Verified Community Expert]

I'm dosing standard alk, mag, ca + quantum bio enhance.

Long story but I believe copper was the initial problem. All new corals are doing well and ploy-filter pads have pulled out so much in the past 2 weeks. BTW this sample was submitted approx 2 weeks ago, so copper definitely lower.

Just not sure if any other elements are out of range

Do you have any idea how the copper got there?

I don't see other significant issues.