Another 6105 issue

[KJoFan]

Roger, could you take a peek at the end of this thread: https://www.reef2reef.com/threads/powerheads-and-profilux-4-compatibility.506952/page-2#post-5728689

Long story short, I believe the pump to be circa 2011 or 2013 or thereabouts, and has had trouble for a little while now running on any pulse or on/off setting. If it gets too low of a percentage set, it will stop spinning. I was running it off the 7095 controller up until yesterday when I hooked it up to my Profilux 4. Now, the prop won't go at all. I've disconnected it and tried it just plugged into the wall outlet directly and still dead.

I can only guess motor block issue, as there's nothing impeding the prop and it was cleaned just a couple weeks ago and when checked yesterday, has no build up or issue I can detect visually.

I actually have two 6105's of this vintage. The other seems to work ok, but is there anything that can be serviced to keep them going?

 

[mtraylor]

You will probably hsve to recalibrate for voltage change

 

[mtraylor]

 

[KJoFan]

You will probably hsve to recalibrate for voltage change

Mine doesn't have the inline 7090 controller. Just those little black boxes with knob to adjust percentage (unless used with a 7095 or 7096 or external controller).

 

[mtraylor]

Oh ok. Yeah i still have one vintage going strong. It may be dead. I cant remember if that little knob on them does anything since i havnt touched it in years.

 

[KJoFan]

Oh ok. Yeah i still have one vintage going strong. It may be dead. I cant remember if that little knob on them does anything since i havnt touched it in years.

I think the knob just adjusts the power of the flow if you don't have it connected to any controller. I could crack it open and see if there's something obviously wrong in there, but you may be right...RIP.