I am wanting to make a needle wheel for my pump and valute . I found a guy online that’s makes them but since he sells them he won’t share the STL .
Anyone made a 3d printed needle
- Thread starter me & my baby
- Start date
- Tagged users None
Reefing Madness
Moderator
Staff member
Super Moderator
Ultimate Member
Excellence Award
Hospitality Award
OP
OP
I know he printed it with white ABS and they hold up really good
OP
OP
Here is the kit he was making. And selling
buddy.
Active Member
I designed one a while back for a DC pump that didn't have a needle wheel available at the time.
I can't remember exactly what type of plastic it was because a friend printed it, but I do know that it is waterproof and non toxic.
If I can find the STL you are welcome to have it but it probably isn't going to fit another type of pump.
I can't remember exactly what type of plastic it was because a friend printed it, but I do know that it is waterproof and non toxic.
If I can find the STL you are welcome to have it but it probably isn't going to fit another type of pump.
Last edited:
OP
OP
That looks cool what software did you use for it . Let me know if you find the STL
buddy.
Active Member
I use Rhinoceros 3D. I can't find the STL... probably long gone on an old hard drive somewhere. Also it was printed in ABS.
If you let me know what you need I could probably quickly make an STL up for you if its not too complicated.
If you let me know what you need I could probably quickly make an STL up for you if its not too complicated.
Similar threads
