Anyone using a kalk reactor and calcium reactor at same time?

acropora4u

2500 Club Member
View Badges
Joined
Mar 10, 2012
Messages
2,722
Reaction score
1,199
Location
here
What state or country do you live in
New York
Rating - 0%
0   0   0
I have been using a calcium reactor for the last 6 months and have stable parameters but very low ph. I just added a kalk reactor to raise ph and hope it’s beneficial. Anyone else ??

32349D5F-B8BB-43FC-808F-51D10E346B5F.jpeg
 
I personally don't add Kalk to my tank, but have seen other post that do run kalk with carx, or just dosing to bring PH up.

But honestly, don't chase numbers. If all is happy and growing at an acceptable low ph, then let it ride.
 
Forgot to mention too is see if you can add more surface agitation to your DT and see if it helps too. Perfect if you had just 1 gyre pointing up.
 
The combination cant be beat (In my opinion)


They complement eachother very well, not only will you have the pH elevation, but using kalk in addition to a CalRx will enable you to tune the reactor much more "mildly" saving CO² and media so you wont have to worry about refilling the tank and media as much.


20200213_075227.jpg
 
The combination cant be beat (In my opinion)


They complement eachother very well, not only will you have the pH elevation, but using kalk in addition to a CalRx will enable you to tune the reactor much more "mildly" saving CO² and media so you wont have to worry about refilling the tank and media as much.


20200213_075227.jpg
Thanks I agree.
 
Yeah, kalk reactors work very well. The only downside is dosing the same amount every day, ie if you just use it for top off water it will vary depending on evaporation. I run mine off a diaphragm pump for 6 seconds an hour, so it's like 35ml and then an ato does the slack top off. A peristaltic pump would be fine if your rodi water is close (mine is 50 feet away). Combined with a fresh air tube for the skimmer and I'm hitting 8.4 daytime to 8.2 nighttime. I also have a decent refugium that runs 18 hours a day. I switched from sodium carbonate two part to a carx three weeks ago and it's only a 0.05 pH hit. That's with alkalinity in the 8-9 range.

Screenshot_20201221-194726.jpg
 
I use 2 part and kalk at the same time. The only thing I would is use it's own doser so you can get it to consistent every day. Its one of the best for higher pH... 7.6 is LOW. You'll noticed mammoth sized gains if you can get it over 8
 

IF YOU HAD TO OPERATE EVERYTHING ELSE MANUALLY, WHICH AUTOMATED SYSTEM WOULD YOU KEEP?

  • Auto top-off

    Votes: 55 59.1%
  • Automated dosing

    Votes: 6 6.5%
  • Mechanical filtration / roller filter

    Votes: 4 4.3%
  • Automated water testing

    Votes: 3 3.2%
  • Automatic feeding

    Votes: 1 1.1%
  • Lighting schedule

    Votes: 16 17.2%
  • Controller and remote monitoring

    Votes: 3 3.2%
  • Leak detection and emergency shutoff

    Votes: 1 1.1%
  • Automatic water changes

    Votes: 3 3.2%
  • None. I prefer to operate everything manually

    Votes: 0 0.0%
  • Something else (explain in the comments)

    Votes: 1 1.1%
Back
Top
Home
Post thread…
Market
What's new