Anyone else have Wifi issues with their new A3? The wireless support is horrible. It would connect to the AP, but would never route correctly after that. I used an old TP Link range extender to connect via Wifi to the LAN port, using the same AP that the Apex would not stay connected to. I even pulled out a spare AP and fired it up to see if it was a compatibility issue, but that did not work either. I also turned on the Wifi on our ISP provided router, that also still did not work. So the one common denominator is the Apex.
All APs are broadcasting 2.4 and are relatively new, the primary one being less than 2 years old. The Apex still reports good signal strength, but will not connect to Fusion or pull up the local web page when trying to use Wifi. It is an A3 Apex (non-pro). I also have upgraded to the latest firmware.
Does anyone know the command to pull the ip configuration and/or routing info (ARP table) via telnet from the A3? I would like to see what IP it is talking on, the one from the LAN port or if any traffic at all is going out on the Wifi connection (including the IP address for the Wifi). Fusion is mis-reporting all of that currently, claiming the LAN IP (supplied by the TP Link wireless extender) is the Wifi IP. So it is all screwed up.
All APs are broadcasting 2.4 and are relatively new, the primary one being less than 2 years old. The Apex still reports good signal strength, but will not connect to Fusion or pull up the local web page when trying to use Wifi. It is an A3 Apex (non-pro). I also have upgraded to the latest firmware.
Does anyone know the command to pull the ip configuration and/or routing info (ARP table) via telnet from the A3? I would like to see what IP it is talking on, the one from the LAN port or if any traffic at all is going out on the Wifi connection (including the IP address for the Wifi). Fusion is mis-reporting all of that currently, claiming the LAN IP (supplied by the TP Link wireless extender) is the Wifi IP. So it is all screwed up.