Apex Fusion Send Fail pH2 CO2 Setup

[mrbee2828]

Hey everyone. I'm trying to program my Apex to control the solenoid on my CO2 tank for the Cal Reactor. I've got the ORP disabled and the pH2 enabled. I have calibrated both probes and readings are right. When trying to modify the outlet, I'm sending the following to the controller via the web fusion:

Fallback OFF
If pH2 > 6.70 Then ON
If pH2 < 6.50 Then OFF

but I get the following error when I hit send:

Send Failed

//Error: line 2 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Feed, SwX, Power, Sun, or Moon // If pH2 > 6.70 Then ON //Error: line 3 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Feed, SwX, Power, Sun, or Moon // I

If I'm reading this correctly, it doesn't recognize "pH2" as a valid keyword. Thoughts?

 

[mrbee2828]

Just a follow up, I never got this to accept pH2 through fusion. I ended it up doing it on the display panel and got it working. If anyone from Neptune sees this let us know if there is a bug or if I did something wrong.

 

[u2coop]

I get the exact same thing and had to take the idiot approach and swap them round, would have thought this was a fairly standard setup so why it doesn't work god only knows why it won't work

 

[MounteeFrag]

Always use Neptune's forum page. Quick answers to all your problems

 

[tigerdragon]

The prob may be with th ph statement i have two ph probes one is pH the other is pHx4. Make sure you are identifying the correct ph probe.

 

[Starboard]

//Error: line 2 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Feed, SwX, Power, Sun, or Moon // If pHcon2 > 6.70 Then ON //Error: line 3

I have the same issue right now and cannot get the darn thing to work correctly. I never touched the settings at all, I just realized my ph controller never turning off. I find it very inconvenient since it's Labor Day weekend and I have to sit here and manually turn it on and off while there is no tech support because they all went to MACNA . Thumbs down on reliability!

 

[mrbee2828]

After a lot of screwing around with this over the last few months on 2 tanks I've figured out it has something o do with the case. I renamed the 2nd probe ph2 vs pH2 and it sends form the web interface and Fusion. Go figure...

 

[w.gurney77]

I was just doing a search on the forum. I came across this thread. How did you calibrate pH2? I can't figure it out.

 

[mrbee2828]

You can't figure out calibration in general or just the 2nd probe calibration isn't working?

 

[w.gurney77]

No problems calibrating all other probes. Could you walk me through pH2 calibration?

 

[mrbee2828]

Rename the probe to a lowercase "h" "ph2".