Apex Guru

[Wasatch.Wired]

I'm looking for the programming to fill a 50gal barrel when a float switch says it's empty, and stop filling when a second says it's full. This is a salt water holding tank that gets drawn from by my DÕS in auto water change mode. I also need the DÕS to shut off until I re enable it after mixing new salt. Thank in advance.

 

[DarthSimon]

I have a Low Sensor and High Sensor in my Salt water mixing station. When the low sensor opens and is dry, the water change, (DOS Outlets for SW and removal water) go off, and Solenoid Valve opens from RODI water supply and fills mixing station. When HIgh Sensor in Mixing station closes, the Solenoid Closes.

Also I have set an Email Alarm if Virtual Outlet AddSalt goes on, so I know the system is in progress of making a new batch. I then will check after a few hours and scope salt and reset Outlets back to "Auto" for Dos.