Apex heater controller

[Matt Winstead]

I randomly get this error any ideas? Controller never loses power. And never turns off.

 

[HuduVudu]

There is programing in your Advanced tab. It looks like if the wattage is less than 1 (<1w). I found wattage to be very flaky with Apex and I stopped using it.

 

[CSJIII]

What type of heather do you have? You may have it set for warmer, to turn off, than your apex is set for.

 

[Matt Winstead]

Pretty sure this was my problem! Inkbird controller

 

[Sisterlimonpot]

sounds like you programmed fusion to send you a message when your heater goes below 1 watt. You can either turn that off in fusion, or like what @CSJIII said, turn the dial on the heater so that it doesn't shut off before the apex turns the outlet off.

 

[phatduckk]

I’d actually turn that off. If the inkbird is plugged into the apex I’d essentially just have the apex shut the inkbird off when you get to 81+ (and on at 76/77) and otherwise let the inkbird do its job.