seawater25
New Member
- Joined
- Oct 8, 2025
- Messages
- 2
- Reaction score
- 0
- Location
- Galveston
- What state or country do you live in
- Texas
I am trying to configure my APEX to run my morning spawning pump on/off protocol automatically after a feed cycle. I have Feed A set up, but can't figure out the coding for Feed B to do the following:
Not interfere with feed A
Execute 7 minute feeding cycle with FeedB that turns off Return and Wave pumps, then all turn back on after cycle ends
At 9:00am, automatically turn off Return and Wave pumps, then back ON at 11:30 - but ONLY when FeedB is activated
I don't use FeedB every day, so I need the pumps to behave normally if FeedB is not activated
Not interfere with feed A
Execute 7 minute feeding cycle with FeedB that turns off Return and Wave pumps, then all turn back on after cycle ends
At 9:00am, automatically turn off Return and Wave pumps, then back ON at 11:30 - but ONLY when FeedB is activated
I don't use FeedB every day, so I need the pumps to behave normally if FeedB is not activated
