Apex wifi questions

[Ryan Rioux]

just hooked up the apex and went to calibrate the probes , after calibration I put the probes into my sump. My salinity is reading 7.1!!!! The temp is also low in the 68 degree range . I'm not sure what's going on with it but if anyone has had this experienceee and can help thank youuuu

 

[Angrywalnut]

The probes need some time in the sump/tank. Mine were wacky for a week. Then I calibrated and they were much closer to correct and holding values.

 

[Ryan Rioux]

The probes need some time in the sump/tank. Mine were wacky for a week. Then I calibrated and they were much closer to correct and holding values.

I tossed the calibration fluids out !!! Should I pick some more up and if so where can I get it !? It said one time use so I thought it was allset

 

[mahindra.dev]

I tossed the calibration fluids out !!! Should I pick some more up and if so where can I get it !? It said one time use so I thought it was allset

Bulk Reef supply is where I picked mine up. I’d get a few as you need to calibrate every few months. I go every 6 months for calibration.

 

[mahindra.dev]

just hooked up the apex and went to calibrate the probes , after calibration I put the probes into my sump. My salinity is reading 7.1!!!! The temp is also low in the 68 degree range . I'm not sure what's going on with it but if anyone has had this experienceee and can help thank youuuu

7.1 on Salinity? are U referring to pH? Or did u use the wrong solution to calibrate?

 

[Ryan Rioux]

7.1 on Salinity? are U referring to pH? Or did u use the wrong solution to calibrate?

salinity says 7.1. I used the correct stuff . When I buy the calibration fluid does it matter brand ? Couldnt find Neptune brand

 

[Ryan Rioux]

7.1 on Salinity? are U referring to pH? Or did u use the wrong solution to calibrate?

 

[leepink23]

salinity says 7.1. I used the correct stuff . When I buy the calibration fluid does it matter brand ? Couldnt find Neptune brand

Make sure the Salinity Probe is plugged in securely, I got a reading like that when mine wasn't plugged in good.

 

[Ryan Rioux]

Make sure the Salinity Probe is plugged in securely, I got a reading like that when mine wasn't plugged in good.

I will give that a shot and worse case I'll order some more calibration fluid and try to calibrate again

 

[leepink23]

I will give that a shot and worse case I'll order some more calibration fluid and try to calibrate again

I ended up speaking with apex because I couldn't get mine to sit right, ended up having to open it up and push the card back in place, then re plug it in and it went from 3 to 35. Good luck!

 

[mahindra.dev]

salinity says 7.1. I used the correct stuff . When I buy the calibration fluid does it matter brand ? Couldnt find Neptune brand

https://www.bulkreefsupply.com/nept...MIsoy5rcKw1wIVW57ACh1_5AsHEAQYASABEgID-vD_BwE

 

[coil1002]

My probe read low when I first put it in it was in the 20's over the next week it climbed up to 45 then leveled out it was only then that I calibrated it and it has been spot on every since. I was worried about it due to all the salinity probes wont calibrate posts I had read. The probe need time to soak from what I read.