Aquamaxx coneS Q-3

Artillerydrill

Active Member
View Badges
Joined
May 25, 2017
Messages
251
Reaction score
176
Location
EL PASO
What state or country do you live in
Texas
Rating - 0%
0   0   0
The skimmer works fine but i think it’s too big for my system. It’s 5 months old. Looking to get 375$ or trade for smaller quality skimmer for tanks around 150 gallons.
26b3107699b171e62b030daa76ab383f.jpg
 
I have the same model but a Q-2 on my 180g and want to go larger for the bio load. just think it over before u want to sell. Now I’m looking for a larger skimmer.
 
That skimmer works very well. I agree with the previous remark. Better to have an oversized than an undersized skimmer. Gives you plenty of buffer for heavier bioload.
 
I’m not even able to keep foam up on it I’ve tried it at all depths from 7 to 9 inches i can’t get it to pull as much as I’ve seen other hobbyist pull with theirs
 
Spent 430$ on it and it just doesn’t perform for me with is depressing. I definitely don’t have a disposable income by any means but i don’t know what else to do
 
More fish and/or one feeding seem like an easy enough solution. I would be at 7-8", start with bubbles at the bottom of the cup, and see where it takes you. There's no way I'd sell that if it were mine lol, I'd feed bricks of food before I give it up :)
 
More fish and/or one feeding seem like an easy enough solution. I would be at 7-8", start with bubbles at the bottom of the cup, and see where it takes you. There's no way I'd sell that if it were mine lol, I'd feed bricks of food before I give it up :)

I feed three times a day (anthias trio) and have 9 fish at the moment. I would consider that heavy bioload for 170 gallons total volume. I’ve been messing with it for 6 months now...I’ve been in the hobby for 17 years and have owned a few skimmers in my day and never had problems.
 
It took about a week for my q-2 to break in Also did U rinse out with vinegar before using. Have mine set at 8 inch deep that worked best for me. Hope that helps make sure yellow air tubing connected in good. Here’s pic

608FF394-B20D-426E-912F-FE8130CF60C4.jpeg


6F03631A-77DB-48BA-BA63-A9694C39DD95.jpeg
 
I just removed my Q3 and replaced with 150 EXT from reef octopus.. had the same problem.. it was too much for my 120 and never got that skimmate that i was looking for.. good luck
 
You still selling. Pm me
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.3%
  • Fish or coral food

    Votes: 5 6.1%
  • Test kits or reagents

    Votes: 8 9.8%
  • Filter media or replacement fleece

    Votes: 4 4.9%
  • RO/DI filters or supplies

    Votes: 13 15.9%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 9 11.0%
  • I keep a backup of everything

    Votes: 21 25.6%
  • Other (Post in the comments)

    Votes: 7 8.5%

New Posts

Back
Top
Home
Post thread…
Market
What's new