ATK Task Error Message

[Wen]

Hello and thank you for helping me figure this out.

Setting up the ATK, have followed directions in task and can't finish the task because I get this error message:

Error: Line 7 - No such output name // If Error Then On

I have gone round and round Fusion, and don't know how to remedy this error. :confused:

 

[SuncrestReef]

I already answered your question on the Neptune forum:

Go into your EmailAlm output program and remove that line of code, save it, then run the ATK Setup task again.

 

[Wen]

It's me again.

Optical sensors working.

PMUP on fusion will indicate that it is on (whether manually switched to on, or when sensors out of water), but the pump is not running.

I have followed the steps in your tutorial regarding a PMUP that won't turn on.

It was connected to the FMM with an extension cable from BRS, so thought that may be the problem. I removed extension cable, plugged it in directly to FMM and still not running.

So PMUP says its on, but it is not. What else can I try? No kinks in tubing... trying it with no tubing in a bucket.

Thank you.