BRS Titanium Heaters - Are they any good?

  • Thread starter Thread starter BZOFIQ
  • Start date Start date
  • Tagged users Tagged users None
I know this is an old thread, but I need to have a moan somewhere.

I came downstairs this morning, and my Inkbird low temp alarm was beeping. A quick peek the Inkbird controller showed a temp of 73.2. My two D-D 350w titanium heaters had both failed after about 12 months (D-D being what these things are badged here in the UK). Red Sea recommend 600w for that tank, so I thought 2x350w would be fine.

I now think these heaters are rubbish.
 
Well, the 4 heaters in my new system are performing fine for past few months. No issues to report just yet but will be sure to post if they crap out prematurely.
 
BRS titanium heaters are pure junk. I went through three 600 waters over the past 2 years. The first one was replaced under warranty after 8 months of ownership. I purchased an additional 600 water to compliment my replacement. The replacement crapped out after 6 months. And my other just went bad the other day. I would say the average life span is no more then 1 year. Hopefully I can find a reliable replacement... never again will I purchase their heaters.
 
Still going strong on all of mine. Some are 4 years old now and not a single failure to date
 
My BRS 300 watt element just went out. Double-checked and confirmed it was not the IB controller. I called BRS, and they were Johnny-on-the-spot. There is one on the way; no need to return and no questions asked. Customer service was great. I'll delay my opinion on quality and durability after having run the replacement for a while. Currently I am pleased.
 
I have had the same brs 300 watt elements heaters for the past 5 years. I’m just now going to replace them for redundancy.
 
Been running 2 -600w for almost 3 year now no issues. Also make it a priority as with all my my equipment to pull them out every 6 months to clean off all the stuff that build up on them so that the heat actually dissipate properly.
 
I run 3X300 watt heaters and keep one on the shelf. Personally I consider any brand of heater as a consumable and cycle them out every 12-18 months. Apex warns me when the outlet isn't drawing juice. Far cheaper than replacing a tank of livestock.
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 11 22.0%
  • Powerheads or wavemakers

    Votes: 4 8.0%
  • Sump or rear filtration chambers

    Votes: 7 14.0%
  • Skimmer or other filtration equipment

    Votes: 6 12.0%
  • Overflow or plumbing

    Votes: 10 20.0%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 11 22.0%
  • Other—tell us what I missed

    Votes: 1 2.0%
Back
Top
Home
Post thread…
Market
What's new