Buffing acrylic

bump #diywizards
 
Im about to try on a 375 i just got. Im guessing the depth of the scratches is going to determine the extent of sanding, but id like to know also.

If i can get away with just buffing that would be great, but im thinking i might have to sand.

From what i have looked up hand sanding seems to work best. Depending on the depth of the scratches people start as low as 400 grit and move up 600, 800, 1000, 2000, and some go 3000 and higher.

Then a foam buffer on a drill with novus 3 then 2.

Ive seen people say they go up and down then side to side with the sandpaper rather than circles.
Also seen someone say they sanded too close to the corners and were having trouble buffing the corners.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new