Cade Chaos Grimoire

[fishguy242]

...

 

[danieyella]

So yes, I was right in my assumption. Their response was to adjust the screws along the groove to center - I included in my email that doing so to the furthest point still doesn't leave it centered. I can put one not in the groove -potentially- to get it to that point though. I'll test that tonight or tomorrow depending on how I'm feeling after work with the crazies.

 

[fishguy242]

Mornin' ,will light mount level if you offset the screw ,which light did you go with ?

 

[danieyella]

Mornin' ,will light mount level if you offset the screw ,which light did you go with ?

2 natura icons, not the max though - 1 wouldn't give good spread, 2 would be overkill.

 

[danieyella]

Mornin' ,will light mount level if you offset the screw ,which light did you go with ?

and that's what we're gonna find out later lol

I have a little spare time to put the mounts together this morning, I think.... but not enough time or the extra hands to get everything up and the old light out fully.

 

[danieyella]

With vs without support bar length

Not to mention I have no idea which random extra hardware to use to secure it on the vertical side because their example photo shows it affixing very differently

Actual:

Theirs:

The actual is much longer, I can see the tiny screw holes that would match on the mounting bars - but the support doesn't have those to use

 

[Reefering1]

What if we skip this bar entirely-

And mount the light directly to the big 90* angled main piece-

Using these screws and washers-

This is assuming that there are 2 angle bars for each light and the screw threads matching the threads on the fixture itself (if they didn't match, I would go to the hardware store and get some that do)

 

[danieyella]

I can look into that tonight when I'm home, but I feel like it'll be too close to the other edge that way

 

[Reefering1]

I can look into that tonight when I'm home, but I feel like it'll be too close to the other edge that way

Then install this piece on the light then those screws and nuts to attach to the main bar.

 

[danieyella]

Then install this piece on the light then those screws and nuts to attach to the main bar.

They never did address what that piece was supposed to be

 

[Reefering1]

And I would use "loctite" on all screw threads

 

[Reefering1]

They never did address what that piece was supposed to be

You probaly mount those to the lights, then to the main bar. And like you suggested- the other bar with the slot and many small holes are if you're mounting light bars with them.

 

[fishguy242]

Really wish I could see all the pics...

 

[Reefering1]

Really wish I could see all the pics...

Try refreshing the page. This morning I had to regress 5 or 6 times before it loaded correct

 

[That Crusso Kid]

Try refreshing the page. This morning I had to regress 5 or 6 times before it loaded correct

You regressed? 5 or 6 times? All at the same time? I feel kind of bad for anyone that might have been around you.

 

[fishguy242]

Mornin' ,toss the lights down the driveway yet ?...
Careful cutting,modifying , may void warranty...
Hoping to see new light pics soon...

 

[danieyella]

Mornin' ,toss the lights down the driveway yet ?...
Careful cutting,modifying , may void warranty...
Hoping to see new light pics soon...

We went out for dinner last night after work and I got the worst acid reflux ever so didn't even attempt.

It's on the list for today