Your test show an unbalanced consumption. With calcium dropping 40 ppm you should have roughly a 5 dkh drop. On the flip side with a drop in alkalinity of .7 dkh I would expect to see the calcium drop around 10 ppm. The ratio that corals use calcium and alkalinity is 18-20 ppm of can to 1 meg/l or 2.8 dkh. This is also close to what would be used in precipitation. Seeing a drop of 40 ppm ca and only .7 dkh alk makes me wonder.
This isn't the first time I've heard people having problems with
BRS supplies. I'm not saying the
BRS stuff is causing problems but I know the calculator can be confusing. I really suspect a testing error in your case.
If say for instance the accuracy of the car test is +-10 ppm. You could have started with 390 ppm and ended with 370. Then if the alk test had a +- .2 diy you could have been at 8.6 and gone to 7.5. That would get your consumption closer to what I would expect to see. I don't actually know what the range of accuracy of red sea test kits are but i am showing a small mistake both ways can make a big difference.
I can say for certain the mag test is a pain. You must follow the instructions exactly. If you don't wait the entire min between adding the last chemical and starting the regent it will be way off.
Get your ca and alk numbers back where you want them. Figure out how much supplement of each you need to add. Test before and after dosing to confirm that the amount dosed actually raised the level the desired amount. You might need to test 2-3 times to make sure exactly where your at.
If it was me I would get my alk and ca up where I wanted them. Then I would start a small dose. Maybe start with approximately .5 dkh and around 5 ppm ca. Manually dose this for 3 days and test and double check and triple check. Then you could adjust the dosing accordingly.