- Joined
- Jul 20, 2018
- Messages
- 892
- Reaction score
- 1,510
Hi. I am trying to use my conductivity probe to control my brine pump. Here are the issues.
1. when I program it as Condx4 - the command is rejected.
2. when I use "Cond" or "Salt" it takes the program, but, does not work correctly.
Example.
If Condx4 < 35.4 Then Off "ERROR" acceptable commands Cond... etc... etc... It will not accept this command line.
If Cond > 35.4 Then OFF
or
If Salt > 35.4 Then OFF - Apex will accept this command line. But, then ignores it.
Example, the Condx4 is 36.5 and the pump just stays ON.
Thoughts.
Why won't it take Condx4 as a command?
Are Cond, Salt and Condx4 the same thing, or no? If the same, then why is the conductivity being ignored?
Do I need to do this on a virtual outlet?
1. when I program it as Condx4 - the command is rejected.
2. when I use "Cond" or "Salt" it takes the program, but, does not work correctly.
Example.
If Condx4 < 35.4 Then Off "ERROR" acceptable commands Cond... etc... etc... It will not accept this command line.
If Cond > 35.4 Then OFF
or
If Salt > 35.4 Then OFF - Apex will accept this command line. But, then ignores it.
Example, the Condx4 is 36.5 and the pump just stays ON.
Thoughts.
Why won't it take Condx4 as a command?
Are Cond, Salt and Condx4 the same thing, or no? If the same, then why is the conductivity being ignored?
Do I need to do this on a virtual outlet?
Last edited: