Chalice fragging question

[khushtram]

Hello fellow reefers!! I’m am not sure if this is the right place to post it or not but here it goes. I have a high end chalice that I’m looking to frag. I do not have access to a band saw at the moment but I do have a cheap dremel that I use for work. Are there any other methods that I can use to frag a chalice without losing the entire piece? It’s a beautiful coral and I would hate to lose it due to fragging it improperly.

Any suggestions ?

 

[tgp4274]

following:)

 

[acro-ed]

I've used a dremel with a diamond wheel countless times with great results. Everyone has their own preferred method but a band saw is not necessary.

 

[ChaosAquaculture]

Dremel will work, lil chalice trick dont cut just eyes out, cut a piece with no eyes at all, you will have 8 eyes on it in a week or 2.

 

[khushtram]

So a diamond whee from a hardware store. How do I go about disinfecting it ?

 

[acro-ed]

I just use dish soap to rinse the wheel off and then water to rinse the soap off.

 

[khushtram]

Dremel will work, lil chalice trick dont cut just eyes out, cut a piece with no eyes at all, you will have 8 eyes on it in a week or 2.

Nice to know thanks