Check out the sump designs!

[KoleTang]

Well it's not V-Ray or anything, but I did my best with sketchup :bigsmile:

So here is the sump for a super secret project that should be let known to the world... soon. Muahahahaha!

Sump -

From left to right

Chamber #1: Area for filter sock/pumps for external skimmer and reactors
Chamber #2: Frag tank area
Chamber #3: It is kinda hard to see, but it is an L shape starting behind the frag tank and ending at the far right. This area is for a refugium. The small box on the far right is the return pump area. (It is actually an inlet for an external pump).​

Mega-ATO Reservoir -

It holds about 38 gallons and there will be a little door on the side of the stand to fill it up.

 

[KoleTang]

BTW. I was not sure what size acrylic would be used. So I calculated 1/4" Acrylic into all of the designs.

LMK if you think 1/4" acrylic is thick enough

 

[KoleTang]

Hmmm... I guess the equipment forum is busy :wink:

 

[skinz78]

Looks good to me! Are you going to have a lid on the ATO resivor?

 

[KoleTang]

Yup :)

Anyone have any input on the acrylic thickness?

 

[nater]

Don't know if 1/4 is gonna cut it. Probably more like 3/8 just because of the length. Maybe some euro brace. Best bet would be to ask troylee.

 

[KoleTang]

Don't know if 1/4 is gonna cut it. Probably more like 3/8 just because of the length. Maybe some euro brace. Best bet would be to ask troylee.

Good point.

I should also add a filter sock holder. :)

 

[KoleTang]

There we go! :)