Cloudly glass!

Tyler_Fishman

Active Member
View Badges
Joined
Aug 14, 2017
Messages
231
Reaction score
126
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
Tank water is crystal clear, it's only in the front of my tank were it's couldy, I've tried everything; windex,vinegar, RO water, it's even gotten to the point where I've contimplated rearaging my rock work to face the clear side of the glass. Any help?
 
Tank water is crystal clear, it's only in the front of my tank were it's couldy, I've tried everything; windex,vinegar, RO water, it's even gotten to the point where I've contimplated rearaging my rock work to face the clear side of the glass. Any help?
Are you sure the cloudiness is on the outside of the glass?
 
i use a magic eraser on the glass, polishes it crystal clear. if you get the original one with no detergents or cleaners it can also be used on the inside of the tank.
 
i use a magic eraser on the glass, polishes it crystal clear. if you get the original one with no detergents or cleaners it can also be used on the inside of the tank.
This would be my suggestion, too.
 
That is incredibly weird. Glass is extremely inert. There is almost no way the glass itself can suddenly become 'cloudy'. You're certain it is the outside surface of the glass? If so, their are only two potential causes that I know of:

1. Something is creating a film on the outer surface. Is the tank near a kitchen and have you fried and foods lately? Have any chemical cleaner been used near the tank? Has anything been done recently in the house that might have caused a fine smoky or oil residue to get into the air (for example,you'd be surprised how much oil vapor can get into the air from the simple act of frying french fries)?

The problem with this potential cause though is that only the front panel is affected and not the sides, and usually a glass cleaner like windex or vinegar will at least smear it ... if not completely remove it ... letting you know it is indeed a film.

2. Is the glass tempered? Improper tempering can cause glass to look hazy. AFAIK though, when it does occur, it is immediately noticeable from the moment the manufacturing process is complete. So, the haze would've been present from day 1 rather than suddenly occurring out of the blue.

That said, if cleaning doesn't improve it in any way, the glass IS tempered, and it is only occurring to that one panel of glass, I would investigate the possibility of defect caused by the tempering process.

If the glass ISN'T tempered, than it has to be something that is building up on either the inner or outer surface.
 
I think it may be a culmination of everything you said, it is where I clean the most, I used to use wet ones, but they left a silt on the glass, now it won't go away, if you look closely you'll notice tiny specks of white on the glass, their I's some salt that spilled on it that I have yet to take care of although

1512679380612743618717.jpg
 
Do you have a full front shot of the tank?
 
I used to use wet ones, but they left a silt on the glass, now it won't go away

Have you tried rubbing alcohol? Either that or the magic eraser would be worth a try.

Wet ones have a moisturizer in them that likely isn't water soluble, but I'm surprised that windex didn't take it off...
 
Have you tried rubbing alcohol? Either that or the magic eraser would be worth a try.

Wet ones have a moisturizer in them that likely isn't water soluble, but I'm surprised that windex didn't take it off...
I'll give rubbing alcohol a try then
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 12 16.4%
  • Fish or coral food

    Votes: 4 5.5%
  • Test kits or reagents

    Votes: 7 9.6%
  • Filter media or replacement fleece

    Votes: 4 5.5%
  • RO/DI filters or supplies

    Votes: 12 16.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 8 11.0%
  • I keep a backup of everything

    Votes: 20 27.4%
  • Other (Post in the comments)

    Votes: 6 8.2%
Back
Top
Home
Post thread…
Market
What's new