- Joined
- Dec 31, 2018
- Messages
- 130
- Reaction score
- 77
I'm on well water and the TDS from my tap is 650.
I have a 7 stage rodi system. No idea the last time the membrane has been replaced.
Not sure the pressure going in (just ordered a guage) but the pressure on my houses pressure tank goes from 45-55 so I'm sure I'm in need of a booster pump.
I always buy colour changing di resin but it never changes colour and I only get about 200 gallons of it going through before I get tds reading of higher than 0 coming out of my di.
I'm thinking I might have co2 in my water.
After the Ro membrane my pH is yellow with a red sea kit so 6 or lower and the alk is 0.7
After the di resin the pH is 6 or lower with an alk of 0.
Would this amount of co2, as I checked out some charts online and it doesn't seem very high but it is present, warrant bubbling my water in between the Ro and di chambers then pump it through?
What kind of a pump would I use to pump it through my di resin after bubbling?
Thx
I have a 7 stage rodi system. No idea the last time the membrane has been replaced.
Not sure the pressure going in (just ordered a guage) but the pressure on my houses pressure tank goes from 45-55 so I'm sure I'm in need of a booster pump.
I always buy colour changing di resin but it never changes colour and I only get about 200 gallons of it going through before I get tds reading of higher than 0 coming out of my di.
I'm thinking I might have co2 in my water.
After the Ro membrane my pH is yellow with a red sea kit so 6 or lower and the alk is 0.7
After the di resin the pH is 6 or lower with an alk of 0.
Would this amount of co2, as I checked out some charts online and it doesn't seem very high but it is present, warrant bubbling my water in between the Ro and di chambers then pump it through?
What kind of a pump would I use to pump it through my di resin after bubbling?
Thx