Completed my Control Panel for my Apex

[FLSharkvictim]

Just need to add a 2nd Temp probe and my salinity probe to my PM2 module and then I will be done. Then I just have to mount all of my controllers and this job will be completed.

Here is where I keep my parameters at all times:
Water Parameters:
Alk: 8.0 dHK
CAL: 420
MAG:1300
Salinity: 1.024
PH: 8.1
--------------------------------------
TANK INFO:
120 display
Ecotech M1 pump
Apex Classic
Apex ALD Module w/ 2 Leak Detector probes
Apex PM2 Module with a Salinity probe & 2nd Temp probe
Skimz 163 DC Montzer Series skimmer
Custom sump / Refuge
2 TUNZE Turbella 6055 Pumps
2 AI Hydra TwentySix HD LED Fixtures
Celestial C35W Maxspect Refuge Spotlight
Aqua UV Ultraviolet Sterilizer 25w
BRS Dual Media reactor
Eshoops IV Master & Slave Doser
Tunze 3155 Auto Top Off
Hard Plumbed with All Spears Gate & Cepex Ball Valves
1'' Sch 40 pipe

 

[dbl]

Looks good, nice and clean. Great job.

 

[TonapahNorth]

Well done. I'm about to start my panel. So I'm checking out everyone else's. Good work

 

[Xclusive Reef]

Just need to add a 2nd Temp probe and my salinity probe to my PM2 module and then I will be done. Then I just have to mount all of my controllers and this job will be completed.

Here is where I keep my parameters at all times:
Water Parameters:
Alk: 8.0 dHK
CAL: 420
MAG:1300
Salinity: 1.024
PH: 8.1
--------------------------------------
TANK INFO:
120 display
Ecotech M1 pump
Apex Classic
Apex ALD Module w/ 2 Leak Detector probes
Apex PM2 Module with a Salinity probe & 2nd Temp probe
Skimz 163 DC Montzer Series skimmer
Custom sump / Refuge
2 TUNZE Turbella 6055 Pumps
2 AI Hydra TwentySix HD LED Fixtures
Celestial C35W Maxspect Refuge Spotlight
Aqua UV Ultraviolet Sterilizer 25w
BRS Dual Media reactor
Eshoops IV Master & Slave Doser
Tunze 3155 Auto Top Off
Hard Plumbed with All Spears Gate & Cepex Ball Valves
1'' Sch 40 pipe

Can I maybe see the other side of that? everyone shows the front but nody shows the messy wires. I am trying to figure out how to mount my apex /electronics, and can't decide how to hide all the wires.

 

[hockeyhead019]

Very sharp looking!

 

[George Lopez]

Can I maybe see the other side of that? everyone shows the front but nody shows the messy wires. I am trying to figure out how to mount my apex /electronics, and can't decide how to hide all the wires.

Use plastic command hooks