Want to ween your CBB off of live food/clams, or, teach him to feed out of this so he's not out-competed in the tank during feeding time (*cough* tangs *cough*)? Then you need this in your life, so does your CBB, hah. The 'inside' ends sit one over the other which is where you place your yummy CBB food. The other end sits on the outside of your tank, connected via waterproof magnets (extra).
Print specs:
Printer: Prusa i3 MK3S+ (top of the line)
Filament: PETG (reef safe!)
Layer height: .07mm (great quality, you don't want gaps in the plastic to allow bacteria buildup)
Parimeters: 2 (standard is 2)
Infill: 15% (standard is 15%, no need to make this strong, your CBB is a gentle soul)
Print time: 7.5h
Cost: $26 (no magnets or felt)
Model:
Holder not shown, will update when I snap a pic
Print specs:
Printer: Prusa i3 MK3S+ (top of the line)
Filament: PETG (reef safe!)
Layer height: .07mm (great quality, you don't want gaps in the plastic to allow bacteria buildup)
Parimeters: 2 (standard is 2)
Infill: 15% (standard is 15%, no need to make this strong, your CBB is a gentle soul)
Print time: 7.5h
Cost: $26 (no magnets or felt)
- Add waterproof reef safe K&J magnets: +$6 ($32 total with magnets)
- Add felt on outside holder (good for acrylic): +$2 ($34 total with magnets and felt or $28 with just felt)
Model:
Holder not shown, will update when I snap a pic