Dart leaking question

  • Thread starter Thread starter biecacka
  • Start date Start date
  • Tagged users Tagged users None

biecacka

Valuable Member
View Badges
Joined
Jan 1, 2012
Messages
2,402
Reaction score
2,189
Location
columbus ohio
Rating - 0%
0   0   0
Hey everyone, came home to a slightly wet floor yesterday and was not happy. Upon inspection, I noticed a very slight but steady leak from my return pump, a dart. I took it apart and cleaned it and checked the seal, it seems to be tear/rip free. What else should I look for and any other areas to check out.
I have attached a picture of the seal and some “knob” thing that is wear I noticed the water dripping from.
Thank you in advance.

Corey

78675E1A-85E6-46D8-8C85-103FE9C02CBA.jpeg
 
Corey, no idea on the "knob" but that is an "o ring".
When in doubt check with manufacturer.
 
The shaft seals are typically what leaks; these are the replacements. They're available from many sources. They wear fairly quickly so always keep a set on hand.

The drain plug ("knob") also has an o-ring.
 
If the threaded knob was leaking, a little teflon tape should fix it.
 
Seals will be the issue. These do run a little warm and could have slight warpage on plastic housing. Place plumbers silicone on seal if you are going to reuse them to keep them pliable
 
And for what it's worth, the manufacturer doesn't recommend petroleum or silicon based lubricants on the seals (premature wear).
 
And for what it's worth, the manufacturer doesn't recommend petroleum or silicon based lubricants on the seals (premature wear).

How does a lubricant "wear" on a surface that is static?
 
I think I may have found the culprit, the "knob" is a drain plug and should have an O-ring with it. I didn't see one but am heading back home to double check that. If not maybe an o-ring from the hardware store would suffice.

Corey
 
O-ring was in tact on the drain plug. I took everything apart, cleaned it up removed any slat creep and put new Teflon tape on everything and it seems to be running fine with no leaks. Will be keeping an eye on it though.
On a side note though, I do have an extra set of seals laying around, how does one change them?

Corey
 
Back off line as it was still leaking. I was unable to get the impeller off so I dropped it off at my LFS and he is going to swap the seals out for me and I hope this works. On another note, I have a backup dart as well, but the impeller on it seems seized up. Any ideas on fixing that thing?

Corey
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new