Lots of good advise. This is what I did and my Dino was gone in a month.
———————-
Whether it is Dino or Cyano, either way you need to help your good bacteria, pods, sponges…to repopulate. Here is what I would recommend:
1) stop all carbon dosing
2) elevate nitrate to around 5-10 ppm while Maintaining phosphate at around .03-.08. This is the new go to for a mixed tank with no algae/cyano issues IF the ecosystem is balanced. This alone will not help.
3) vacuum/blow the surfaces to release the surface or the Dino/cyano and at the same time use combination of coral snow and MB7 or any other bacteria mix(not nitrifying bacteria). What you are doing here is putting a layer of good bacteria to get hold of the surfaces. 1ml MB7 per 10 gallon of water and 1 ml coral snow per 25 gallon of water. It’s good to blow the surface right before light is going down and to dose MB7/coral snow right after the goes out. Last thing on this. Dose the combo one of twice a week. MB7 should be added daily during this period. It’s possible that you might have to dose nitrate and phosphate to not negatively impact your corals. Follow number 2.
4) Use A good UV to kill any floating bacteria in the water column
5) for first few days use a 10 micron filter sock, especially while blowing the rocks/vacuuming the sand, you can vacuum directly in the sock…
6) feed some photo/zoo plankton combo to increase the pod population
7) patience. Nothing happens fast in this hobby
i have used to this to tame even the worst Dino/cyano in 7 days. It takes a month to fully go away.
let me know if you have any questions. Seems like a lot of steps but some of them are just good practice for healthy corals.
Sam