Does anyone know how to disable the safety shutoff mechanism for DOS? I'd like the DOS pump to continue to dose (top off) the sump until the sensor ATK1 is closed.
After a while of dosing, the DOS will shutoff, presumably as a safety precaution to prevent an OD or flood. However, I am using the DOS as an ATO, so sometimes it takes a while to top off. In these situations, the safety mechanism kills the DOS before it is able to fully top off. After a few times of this, the DOS will be "hard off." The fix is to switch the DOS to the ON or AUTO position, and then back to the AUTO position. Coding doesn't seem to work, as the DOS isn't meant for this use case:
Fallback OFF
Set OFF
If ATK1 OPEN Then ON
If ATK2 CLOSED Then OFF
Defer 000:05 Then ON
When On > 060:00 Then OFF
Defer 000:15 Then OFF
After a while of dosing, the DOS will shutoff, presumably as a safety precaution to prevent an OD or flood. However, I am using the DOS as an ATO, so sometimes it takes a while to top off. In these situations, the safety mechanism kills the DOS before it is able to fully top off. After a few times of this, the DOS will be "hard off." The fix is to switch the DOS to the ON or AUTO position, and then back to the AUTO position. Coding doesn't seem to work, as the DOS isn't meant for this use case:
Fallback OFF
Set OFF
If ATK1 OPEN Then ON
If ATK2 CLOSED Then OFF
Defer 000:05 Then ON
When On > 060:00 Then OFF
Defer 000:15 Then OFF