Dorso plumbing help

  • Thread starter Thread starter colekeene
  • Start date Start date
  • Tagged users Tagged users None

colekeene

New Member
View Badges
Joined
Nov 14, 2014
Messages
10
Reaction score
0
Location
United States
Rating - 0%
0   0   0
Overflow box is staying consistent and does not make much noise. But coming from the Bulkhead into the sump surges and gurgles making a lot of noise any suggestions?
 
How low does your drain go below the waterline in your sump? Pictures of your setup?
 
How low does your drain go below the waterline in your sump? Pictures of your setup?
Top of the drain is higher than the over flow. It came as a kit so I did not trim anything.

IMG_20180121_180041.jpg


IMG_20180121_180052.jpg
 
Looks like a clean set up but I was referring to where the pipe from your drain line enters your sump. How deep does the main drain go below the water line? Circled in red on my pic:)
Screenshot_20180121-172038.jpg
 
Looks like a clean set up but I was referring to where the pipe from your drain line enters your sump. How deep does the main drain go below the water line? Circled in red on my pic:)
Screenshot_20180121-172038.jpg
From bulk head to sump the hose is about 4" under water inside the filter sock.
 
I would first trim that a little bit shorter to stop about 1-1.5" below the waterline and see if that helps. And thank you for the pictures :) Also do you have a valve of some kind on your main siphon?
 
Last edited:
I would first trim that a little bit shorter to stop about 1-1.5" below the waterline and see if that helps. And thank you for the pictures :) Also do you have a valve of some kind on your main siphon?
Shortened with no change the water seems to have lots of air, it bubbles like crazy in the filter sock. Drain just has a small hole with a tube stuck in it so not adjustable.

15165861152731938377361628324570.jpg
 
I have the same problem with an aqueon. I've tried adjusting the hight of the overflow and building a bubble trap to cut down the air going into my fuge. Have you found a solution? I wonder if a needle valve on the bleeder tube would work.
 
Any updates on this? I set up a 125 for my son and it’s surging like crazy.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 14 17.7%
  • Fish or coral food

    Votes: 4 5.1%
  • Test kits or reagents

    Votes: 8 10.1%
  • Filter media or replacement fleece

    Votes: 4 5.1%
  • RO/DI filters or supplies

    Votes: 13 16.5%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 9 11.4%
  • I keep a backup of everything

    Votes: 21 26.6%
  • Other (Post in the comments)

    Votes: 6 7.6%
Back
Top
Home
Post thread…
Market
What's new