I am sure this is discussed here someplace but my searching has been unsuccessful.
I setup a new doser a month ago and I think I might have done it wrong.
The dosing container is below where the doser is mounted. The dosing container has an air hole to prevent pulling a vacuum.
I have the discharge tube dripping into the return pump chamber of my sump.
BUT the discharge tube has twice stopped working, with the end of the Alk 2 Part crystalizing. I have the tubing about 2 inches above the water level. I was thinking I did not want to have a tube that could start a siphon.
Should the dosing tubing be in the sump water?
Thank you
I setup a new doser a month ago and I think I might have done it wrong.
The dosing container is below where the doser is mounted. The dosing container has an air hole to prevent pulling a vacuum.
I have the discharge tube dripping into the return pump chamber of my sump.
BUT the discharge tube has twice stopped working, with the end of the Alk 2 Part crystalizing. I have the tubing about 2 inches above the water level. I was thinking I did not want to have a tube that could start a siphon.
Should the dosing tubing be in the sump water?
Thank you