Dosing pump location?

[jonelder68]

Getting ready to install my kamoer fx-stp dosing pump and avast kalk reactor. Wanted some opinions on mounting location for the kamoer.

I believe both ways should work fine? Option 1 or 2? Either way the dosing pump is above water reservoir. Only difference is outlet pumping up a foot or so or outlet going downhill. Option 1 with dosing pump below control panel allows easiest access for maintenance. Sorry for the high quality drawings .
Red = kamoer pump
Black = avast kalk reactor
Blue = water lines

 

[Snoopy 67]

I would opt for #2 with a board behind the Kamoer to bring it out a little more.

 

[Dread Pirate Dave]

I'd go with the easiest access for maintenance. :)

 

[Solo McReefer]

What a cute little white Brute container

 

[Uncle99]

Doesn’t the pump need to be below the point of entry into the tank to prevent any potential for gravity to overdose if the pump fails?

So I like number 1

 

[scotty333]

Doesn’t the pump need to be below the point of entry into the tank to prevent any potential for gravity to overdose if the pump fails?

So I like number 1

Nope , gravity isn’t a part in dosers the tubes are in constant close and solution is pulled through by a triangular wheel

 

[Uncle99]

Nope , gravity isn’t a part in dosers the tubes are in constant close and solution is pulled through by a triangular wheel

Ok, mine could stop in open which would lead to disaster. If it stops in any way when lower, worse case liquid moves back to bottle.

 

[scotty333]

All the dosers operate the same way they have 3 contact points in a triangular formation so there’s always one contacting the housing

 

[jonelder68]

All the dosers operate the same way they have 3 contact points in a triangular formation so there’s always one contacting the housing

The kamoer fx-stp actually has a 6 roller drum. But yes, works exactly the same.

 

[scotty333]

The kamoer fx-stp actually has a 6 roller drum. But yes, works exactly the same.

Well I didn’t know that , only took a few apart donkeys years ago when I had a used tanks/equipment / livestock shop so sure I’m sure newer versions are updated but as you say they have the same function , there’s always a contact point between the tube and plastic screw thingymebob ( sorry no idea what to call them but you know anyways)

 

[jonelder68]

Well I didn’t know that , only took a few apart donkeys years ago when I had a used tanks/equipment / livestock shop so sure I’m sure newer versions are updated but as you say they have the same function , there’s always a contact point between the tube and plastic screw thingymebob ( sorry no idea what to call them but you know anyways)

Pretty clever design. Believe 3 rollers are in contact at a time. Triple protection.

 

[scotty333]

Pretty clever design. Believe 3 rollers are in contact at a time. Triple protection.

Triple protection !

 

[Snoopy 67]

They, Kamoer, do have a 3 roller option in their parts.