Ecotech mp40 problems

[Morten1234]

Hi
So this morning i found my mp40s had stoped running and were flashing white. They are running off wxm modul and were running just fine Yesterday . i can turn them on with the o but the just run at full speed

 

[hdsoftail1065]

Bump

 

[DarthSimon]

You can try resetting your driver and re attaching the Vortechs to the WXM.

Get Started | Vortech Configuration and Programming via ApexFusion

Helpful Resources Comprehensive Reference Manual WXM Eco Tech Manual WXM Troubleshooting Forum Introduction This Get Started Guide will assist you in connecting and configuring your Ecotech Marine Vortech Pumps with the Neptune

www.neptunesystems.com

 

[Morten1234]

Did that but its still the same. But it seem to when i put them in constant mode at night

 

[DarthSimon]

Can you go into your modules page and take a screen capture of your WXM's configuration page and post it here please.

 

[Morten1234]

 

[DarthSimon]

Looks like your Vortech's are Attached. So what exactly isn't working?? Do you have your 2 Outlets?

 

[Morten1234]

Yes i have. At night it’s set to constant speed and when it does that the pumps blinkes white. I know i can just set it to somthing else but i just dont understand why

 

[DarthSimon]

Please post your Vortech Schedule...

 

[Morten1234]

Well it’s running normal now. But thanks anyway:oops: did a reset and this time it works

 

[DarthSimon]

Great!! Good news... let us know if you need any further help.

 

[SeniorReefer]

Hi
So this morning i found my mp40s had stopped running and were flashing white. They are running off wxm modul and were running just fine Yesterday . i can turn them on with the o but the just run at full speed

Got the same problem, but figured it out,it is when the pump is running to slow. Below 20% its going in feed mode flashing white. Just set the pump to run faster and upload the scheme and its working normal again

 

[Morten1234]

That would explain why it’s running normal now it’s in reefcrest at highere speed