Ecotech mp40 problems

[Morten1234]

Hi
So this morning i found my mp40s had stoped running and were flashing white. They are running off wxm modul and were running just fine Yesterday . i can turn them on with the o but the just run at full speed

 

[hdsoftail1065]

Bump

 

[DarthSimon]

You can try resetting your driver and re attaching the Vortechs to the WXM.

https://www.neptunesystems.com/getstarted/wxm/vortech/

 

[Morten1234]

Did that but its still the same. But it seem to when i put them in constant mode at night

 

[DarthSimon]

Can you go into your modules page and take a screen capture of your WXM's configuration page and post it here please.

 

[Morten1234]

 

[DarthSimon]

Looks like your Vortech's are Attached. So what exactly isn't working?? Do you have your 2 Outlets?

 

[Morten1234]

Yes i have. At night it’s set to constant speed and when it does that the pumps blinkes white. I know i can just set it to somthing else but i just dont understand why

 

[DarthSimon]

Please post your Vortech Schedule...

 

[Morten1234]

Well it’s running normal now. But thanks anyway:oops: did a reset and this time it works

 

[DarthSimon]

Great!! Good news... let us know if you need any further help.

 

[SeniorReefer]

Hi
So this morning i found my mp40s had stopped running and were flashing white. They are running off wxm modul and were running just fine Yesterday . i can turn them on with the o but the just run at full speed

Got the same problem, but figured it out,it is when the pump is running to slow. Below 20% its going in feed mode flashing white. Just set the pump to run faster and upload the scheme and its working normal again

 

[Morten1234]

That would explain why it’s running normal now it’s in reefcrest at highere speed